Nemco-food-equipment Dual Shelf Merchandisers Slant Series - Operations Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Cuisine Nemco-food-equipment Dual Shelf Merchandisers Slant Series - Operations. Nemco Food Equipment Dual Shelf Merchandisers Slant Series - Operations Manual User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 6
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
1
NEMCO SLANTED 2-SHELF MERCHANDISER
MODEL SERIES: 6480-18S, 6480-24S, 6480-30S, 6480-36S
OPERATING INSTRUCTIONS
INTRODUCTION
1. Read These Operating Instructions thoroughly before installing or using this Equipment. Improper installation or use can result in
equipment or property damage, electric shock or personal injury.
2. The Nemco 2-Shelf Merchandiser is heavy duty and is designed for commercial use.
3. Only trained personnel should operate this equipment.
4. The Nemco 2-Shelf Merchandiser is designed to maintain the safe serving temperature of precooked food items. It is not designed
for cooking.
SAFETY INSTRUCTIONS
1. IMPORTANT: Clean machine thoroughly before first use and after all uses, using cleaning instructions below.
2. IMPORTANT: Incoming power MUST be the same as the equipment’s rating. Refer to the Electrical Ratings listed on the
equipment’s Data Tag Located on the side of the unit.
3. CAUTION: This unit’s power cord is equipped with a GROUNDED, 3-prong power cord. Plug only into a matching, grounded outlet.
DO NOT cut or break off the third prong. Operating this equipment without proper grounding may result in electric shock.
4. CAUTION: Always disconnect Power when not in use and before cleaning or servicing.
5. CAUTION: Do not operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use
authorized service for examination, electrical or mechanical adjustment or repair.
6. CAUTION: Equipment surfaces are HOT during use and a short time after disconnecting the power. Allow to cool before moving or
servicing.
7. WARNING: DO NOT immerse in water or other liquid. DO NOT clean with water jet. SEVERE personal injury or death can result.
ELECTRICAL REQUIREMENTS
1. The electrical ratings are listed on the equipment’s Data Tag located on the side of this equipment.. Refer to model data chart
2. This equipment must be properly GROUNDED.
PREPARATION
1. Remove all packing pieces and lift unit out of the box.
2. Remove any outside packaging.
3. Caution: Glass is packed separately in carton. Do Not Discard. Refer to Glass Installation Instructions.
4. Set unit on a flat surface. REFER to SAFETY INSTRUCTIONS No. 1 above.
5. Position unit near the power outlet. Do not use extension cords. Do not run cord under carpeting or cover with runners or the like.
Arrange cord where it will not be tripped over.
6. This appliance has hot and live electrical parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or
stored.
7. Unit must be operated with legs installed. Install legs by screwing into nuts located on bottom of unit.
8. Install Glass panels. Place edge in top channel, swing into bottom channel and lower into place.
9. Remove any plastic coating that may be affixed to exterior surfaces.
10. Caution: Dividers and dividers rods packed separately in carton. Do Not Discard. Refer to Divider
Installation Instructions.
11. Install dividers and divider rods. Place divider on shelf by sliding onto divider posts. Install divider rods into slots located on
dividers.
12. If unit fails to work properly when first operated, call NEMCO customer service at 1-800-782-6761.
OPERATION
1. Plug the unit into the power supply.
2. Turn on/off switches to the on position.
3. Turn temperature controls to desired temperature. Note: Allow unit to preheat for 30 minutes before use.
Knob setting LOW: temperature is at 120º-140°F
Knob setting MED: temperature is at 140°-165°F *TEMPERATURES VARY WITH TYPES
Knob setting HI: temperature is at 165°-185°F OF FOOD PRODUCT
4. Place food product on shelf, centered under the heating element.
5. To disconnect appliance, turn controls to off and remove plug from outlet.
WARNING: DURING NORMAL OPERATION, THE EXTERIOR OF THE UNIT IS HOT.
CLEANING
NOTE:
Proper maintenance plays an important part in the life span and functioning of the unit.
1. Move the power switch on both shelves to the OFF position. Unplug the power cord.
2. Allow the unit to cool 30 minutes.
3. Wipe down the unit using a damp cloth or sponge and hot detergent water.
4. Rinse by wiping with a clean damp cloth.
5. Wipe dry.
6. Do not immerse in water or other liquid.
Vue de la page 0
1 2 3 4 5 6

Résumé du contenu

Page 1 - OPERATING INSTRUCTIONS

1 NEMCO SLANTED 2-SHELF MERCHANDISER MODEL SERIES: 6480-18S, 6480-24S, 6480-30S, 6480-36S OPERATING INSTRUCTIONS INTRODUCTION 1. Read These Ope

Page 2 - ELECTRICAL DATA CHART

2 SERVICE INSTRUCTIONS 6480 SLANTED TWO SHELF MERCHANDISERS If the unit fails to operate properly, call NEMCO customer service toll free at 1

Page 3 - 6480 EXPLODED PARTS DIAGRAM

3 6480 EXPLODED PARTS DIAGRAM

Page 4 -

4 NEMCO SLANTED 2-SHELF MERCHANDISER Glass Installation Instructions INSTALLATION 1. Caution: Glass packed separately in carton. Do N

Page 5

5 NEMCO SLANTED 2-SHELF MERCHANDISER Divider Installation Instructions INSTALLATION 1. Caution: Dividers and Divider Rods packed separ

Page 6

6 NEMCO SLANTED 2-SHELF MERCHANDISER Sign Kit Installation Instructions (If Equipped) INSTALLATION 1. Caution: Sign kit parts packed s

Commentaires sur ces manuels

Pas de commentaire